Victory Motorcycles with 5-speed manual gearbox is a transmission that is a little short. First report is almost unusable, and high speed is not high enough. These two teeth left pulley makes your bike more user friendly.
Victory Overdrive Pulley 32 teeth. Fits all 03-05 and 99-01 with Victor Victory Motorcycles upgrade transmission. This pulley RPM drops by 7% and uses all factory parts. I decided to install the pulley on MJ 2004 Victory Kingpin and write the installation instructions step by step with pictures of the installation. Photos can be viewed on the site of the Victory Kingpin cruise on the following link http://www.kingpincruisers.net/coppermine/thumbnails.php?album=56. Here are my working documents for the installation.
I was doing other maintenance and decided to put the bike into a wall.
You do not have to remove the wheel. In fact, you want to leave it to assist in the removal of the crown.
I removed the slip-on exhaust part of the first reduction in the emissions.
Remove the belt cover.
Remove the card reader on the right soil, you can pull the exhaust gases.
Before removing the exhaust.
Note the condition of the exhaust nuts.
The bolts for the exhaust flange may be rusty. Spray with WD-40 and let stand overnight to soften them.
Upon receipt of this remove nuts, remove the exhaust.
Here, the Kingpin is removed by all.
On the exhaust, belt cover, floor panel right driver.
Not the wheel need not be removed. In fact, it must be installed to assist in the removal of the crown.
Remove exhaust. You are hatched in the boxes here.
Take off the exhaust, the sprocket pulley cover.
With the lid you see Sprokect hold gear.
Here is my belt. You want to fit and the wheel, as it is used as a resistance when the mother removiing spocket.
Another photo on the right side of the Kingpin stripped completely.
Remove the screw and gear locking plate striking.
Remove the strike plate motion.
» Read more: Turbotec Drive Sprocket Pulley Installation for Victory Motorcycles